Jump to content
SAU Community

Recommended Posts

so in second and third if you get it up to baout 4700 4800 rpm it starts to go from the ususal brrrrrr to bdrbdrbdbrbdbrbdbr kind of sounds al lose acceleration and just pretty much peak

what could be the cause. ask if more info is needed

its a 1994 r33 rb25det

Link to comment
https://www.sau.com.au/forums/topic/427101-r33-spittinglosing-powed/
Share on other sites

Once your airflow reaches a set level as measured by the Air Flow Meter it will richen your fuel map and retard the timing to protect the motor. This is assuming you have the stock ECU of course

And while the coil packs mat be new the loom probably isnt.

I would

1. Change plugs.

2. Clean the contacts in the coil packs between the pug and the coil pack AND coil pack and loom

3. Use the contact cleaner on your AFM element

If the problem persists turn your boost down until it stops, you are effectively reducing your airflow below the threshold doing this.

if it still persists think of ordering a new loom from nissan

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...