Jump to content
SAU Community

Recommended Posts

Hi,

Looking to ditch the bike and get back into playing with cars.

Not game enough to have too much fun on the bike, and miss having something to take for a hill squirt or track day. Have two kids, mortgages etc, so not willing to give it a go on the bike.

It's a 04 Kawasaki Z750

It only has 21500kms on it and I am the third owner.

Owner before me had two bikes, as well as a boat and a second car, so did not get a huge amount of use.

Owner before that, apparently, had a number of bikes and only was selling this one due to cancer and no use.

Full service history.

No mods apart from aftermarket mirrors.

No accident history.

Bike is in great condition. Could nearly pass for a new bike it's that clean.

It's always kept undercover, even when I take it to work, hence the workshop pics bellow.

Looking for $6500 firm or willing to swap for a s13 or s14 with cash either way.

Not looking to put a lot of cash on top, so s15's would be out, unless you want to get rid of it cheap. Real cheap.

Silvia wise, ideally looking for s14, but either model has to have no accident history, no sunroof and preferably manual.

IMG_0268.jpg

IMG_0085-1.jpg

IMG_0266.jpg

IMG_0084.jpg

Link to comment
https://www.sau.com.au/forums/topic/427741-kawasaki-z750-for-sale-or-swap/
Share on other sites

  • 1 month later...


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...