Jump to content
SAU Community

Can Anyone Think Of A Way To Lubricate A Turbocharger Shaft With No Oil Supply? Serious Question


Recommended Posts

Ready to be flamed for the odd, unrelated question...

But I had no idea what section I should post this in, but this is a very odd yet serious question.

Im using the centre cartridge, turbine wheel and turbine housing from an old turbo for a project not really related to engines/ cars etc. The turbine wheel will not be exposed to heat levels as high as it would straight out of the motor, and I dare say it would be spinning considerably slower. No compressor wheel/housing.

There is no real way to plumb oil or water coolant lines to the turbine without spending a considerable amount of time / money.

Can anyone think of a way to keep the turbo from breaking? I have no real serious knowledge about lubrication systems, but could a high temp bearing grease be used perhaps?

Any info or ideas would be appreciated...

If it still has the centre then plug the oil holes and fill it with engine oil, or pump it full of grease like you suggested, which may be the better option

Grease may be to thick I am thinking now that I start to use my brain a bit. Perhaps pumping it full of engine oil, with a small sump fixed to turbo for it to feed in and out of could work. The oil wouldnt be going through a motor, so it would last longer? The sump could have a drain and fill for servicing...

Someone tell me why this wont work before I waste money.

Why don't you elaborate more on the project, then we could get an idea of what would be required from the lubricant?

The fact it's not exposed to a large amount of heat or RPM may mean you could get away with a thinner oil and therefore less friction / more efficient rotation. You may not even have a need for a sump, but more details on the project would help with recommendations.

Is this a DIY turbojet or something? If you are keeping the turbo stationary, a gravity fed oil drip would do the trick, otherwise a small 12v pump would supply plenty of oil. Dont use grease....

Look at what the manufacturer of the turbo specifies.

Look at what the turbo was originally fitted to.

Also, Lubrication of shaft hehe.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • How many of you guys run the synchro os giken set and at what power? Do you then also use the billet plate?  How is it launching with it, any dragy times from 0-60? 60ft?
    • Oh, also, forgot to add these photos I believe.
    • Thought i'd update on this. I was able to get in contact with Craig Lieberman and later on Darryl Alison (owner of Kaizo Industries). Darryl was able to help me verify that my car was in fact one of theirs and is helping me find more info on mine !
    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
×
×
  • Create New...