Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

We already have that in a way, with the skidpan at gympie and the area at qr the issue is that theyre too expensive and far away

Mt Cotton skidpan is awesome fun. And not as far away as Gimpy

couple pics of new zed

Underneath is mint (cept oil leak from sandwich plate)

Posted Image

Engine out

Posted Image

Traditional zed pic - sitting in empty bay with drink in hand

Posted Image

looks damn clean and tidy there Mike

But it's government run.. gympie is private.

im guess in its because Govt owned probably means more stringent rules to follow due to bureaucracy . Otherwise I cannot identify why differences in ownership would really matter.

Being private could mean they can charge higher fees because they can.

looks damn clean and tidy there Mike

Yep. Rear subframe had been stripped right down (new bushes etc) and fully cleaned and painted. Even axles, diff etc.

Same with gearbox, been cleaned and painted.

We already have that in a way, with the skidpan at gympie and the area at qr the issue is that theyre too expensive and far away

I was going to throw the abomination on the wetpan not so long ago at the drift night.... They wanted 70 bucks for it. Fuark that

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I'll get one of these also just for giggles
    • I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
×
×
  • Create New...