Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

It's good, a bit of a pain to clean properly though.
yeah but it's all worth it mate.

I clean it in hot water and then tip it upside down on a paper towel to dry.

Don't wipe the inside just let it dry

Will genuine Nissan Japan seatbelts pass RWC in QLD?

I know that you can't use them for compliance, but whoever imported my car did a dodgy and must have used a new set to swap in and out again, wasn't to worried about the quality of the Japense seatbelts so never changed them, but of course if they won't get a RWC I will need to.

Will genuine Nissan Japan seatbelts pass RWC in QLD?

I know that you can't use them for compliance, but whoever imported my car did a dodgy and must have used a new set to swap in and out again, wasn't to worried about the quality of the Japense seatbelts so never changed them, but of course if they won't get a RWC I will need to.

Most people Ive dealt with to get a RWC are quite relaxed when it comes to getting a car you already own looked over to be registered by for you. Its normally ones where you're going to sell the car they get a bit pedantic

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
    • Nice, that's not laggy swtching between functions at all. Could it be less laggy than the factory one below? 😋
×
×
  • Create New...