Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Morning everyone.

Bunta, thanks for recommending battery doctor. My phone actually lasts during work now although it still had to be plugged up. Apparently it doesn't like charging over USB...

No worries.

Howdy all Ecu dropped at store for modifications for rb25 should be 125 and mines afm plug is ordered going to be taking that to an auto elecy to do

All that is left now is some ball joints, shocks, front mount, highflow, sub frame and diff bushes, clutch and brakes

Already have a stockpile of parts at home and in the car.

Just over 2g left to spend and I'm done :D

Then spending all the kesh on the 25/30!

what power capable high flow?

you will likely need a bigger turbo if you go the 3L, they are very much a GT30 sized unit minimum deal.

This. If your putting a new turbo on your 25 only to latter add it to your 25/30. I reckon it needs to be a GT35 or bigger. As Tits said GT30's are a minimum but to get a decent number from it you should be looking at a 35 or equivalent

Howdy all Ecu dropped at store for modifications for rb25 should be 125 and mines afm plug is ordered going to be taking that to an auto elecy to doAll that is left now is some ball joints, shocks, front mount, highflow, sub frame and diff bushes, clutch and brakesAlready have a stockpile of parts at home and in the car.Just over 2g left to spend and I'm done :DThen spending all the kesh on the 25/30!

sounds exciting Zac ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...