GREDDY T88-33D Specs

[T88 ON BOARD]

Does anyone know Details specs of a Trust T88-33D

wheel diameters, Housing sizes, HP flow etc...All detail will help!!

Post here

cheers

Tony

[RNS11Z]

Well my turbo had a .66 front wheel and 1.05 rear whel... apparently was rated at around 800hp. On my rb25 was on full song at 5k... was making boost from 3000rpm. This was the non ball bearing version. When tune time came on 24psi it made 345rwhp. At a dyno comp with 20-21psi and some faults it made 420rwhp on pump. No additives like octane booster either.

Over all i thought it was a good turbo. If you plan to use it on a rb25 make sure you use some cams in it and boost it up to around 30psi. Then again every tuner and engine builder is different.

Harun

[sweetr33]

gee u really know what hp is dont u RNS11Z. Wish i could say mine made 420 on pump fuel on 21psi. lol.

[T88 ON BOARD]

Its on a GTR R33 at the moment with big cams ready for big boost....But was hoping to get all the specs on the turbo

[Guest INASNT]

gee u really know what hp is dont u RNS11Z. Wish i could say mine made 420 on pump fuel on 21psi. lol.

yes its quite a piss poor effort getting only 420rwhp at 21psi from a 800hp turbo.

[aybee]

i didnt think any of the trust turbos were ball bearing?

t88-33d came in both 15 and 18cm2 exhaust housings

[aybee]

my turbo chart puts it at 820ps

compared to 34d at 850ps

[sweetr33]

yes its quite a piss poor effort getting only 420rwhp at 21psi from a 800hp turbo.

i didnt think of it that way, so i guess u are right in a way. No dramas