Jump to content
SAU Community

Recommended Posts

What size are the tyres and do you have any photo's of the wheels themselves?

Any chance you fitted them to your 34 gtr? Just not too sure on inner clearance between rim and coil is all

Link to comment
https://www.sau.com.au/forums/topic/432091-te37sl-18x11/#findComment-7030365
Share on other sites

These wheels are designed around the 33/34 GTR

I run the same size rim and offset in RE30cs on the 34 GTR and there fine

This is a pic as they sit on my 33 with 285/30/18 Dunlop 03G.

Pics from importmonster are of rim as they are, as they have just been unpacked,

tyres mounted and put onto the car.

p.s. Willing to swap for 19inch rims

post-31999-0-00332300-1379819445_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/432091-te37sl-18x11/#findComment-7030625
Share on other sites

there 18 inch by 11 wide and won't fit a 34 without some guard work

This becomes confusing and misleading for potential customers dude

If anything, the inner plastic guard might rub under full lock.

A 8mm spacer at the front will get these babies on a r32 gtr with some guard work on the back.

Link to comment
https://www.sau.com.au/forums/topic/432091-te37sl-18x11/#findComment-7030628
Share on other sites

Yeah im currently running a 19x11 +6 on the front of mine and was just a little worried about the clearance between the wheel lip/sidewall and the coilover but it sounds like thats not an issue.

I have pm'd you

Link to comment
https://www.sau.com.au/forums/topic/432091-te37sl-18x11/#findComment-7030783
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • If there's enough meat in the housing where you want to put the M12 adapter, then do it, but be aware that if/when you f**k that up you'll probably be repairing it before doing anything else. I'd just drill it out and tap ina 1/4" thread. No need for rocket surgery when the next most obvious thing will do. You could throw a 1/4 x 1/8 bush in there and use the same fitting you intended to use.
    • Is the only issue that the oil catch can is getting filled on hard runs? I'd be thinking more about oil control issues rather then the head lifting, especially as you aren't seeing spiking in the coolant pressure.  Do you need restrictors in the head, or better drains from the head? Does the sump need venting to the catch can?
    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
×
×
  • Create New...