Jump to content
SAU Community

Idling Very Strange And Sometimes Stalling

HYBRID VL

By HYBRID VL,
in General Maintenance

 Share

Recommended Posts

HYBRID VL Community Regular

HYBRID VL

Posted
Posted

ok noticed this with my car when i 1st bought it a few years ago would idle between 1000-400rpm boucing while stationary like at lights in driveway morning warmup stuff like that now only yesterday my car was idling whilei was in the garage and it stalled i was like hmmm strange so i went and started it back up and it would not start so i poped the bonnet and checked the AFM plug and just had a look and then qwent back cranked it and it started let it run abit then it died again then i started it and it ran and then died again.

didnt know hat the prob was as i have never had it just die like that so i gave it an oil change and filter i hardly drive the car i have had the car for 4 or so years bought it on 99k and its up to 108ks.

Now im just wondering what the problem might be im thinking maybe this idling problem is all connected with the stalling i have a Vid of the idling but it didnt stall i just have to reduce the vid size from 850mb so i can upload it to youtube and link here.

My thoughts were AFM though i was told unplug it and if the car dies it isnt your AFM so tried that and the car died so thats one thing if its true.

AIC valve maybe dirty so i might pull that off and clean it this weekend coming.

also i thought maybe Air filter dirty or maybe fuel filter so ill change all them this weekend aswell.

see how things go any thoughts much appreciated.

HYBRID VL Community Regular

HYBRID VL

Posted
  • Author
Posted

car is pretty much standard apart from a Pod filter and a cat back 3 inch nismo exhaust it runs standard boost and ECU hasnt been modified at all standard BOV aswell no i havnet cleaned the AFM yet its on my to do list for this weekend do i read to use brake caliper cleaner for that.

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

Unplug your O2 sensor and see if the problem goes away.. a dead/faulty O2 would do that as the ECU dumps in waaayy too much fuel thinking it's leaning out when idling

Wongy Proficient

Wongy

Posted
Posted

My car had similar problems, it stalled sometimes during idle and then I went to start it and wouldnt crank over, and sometimes when im driving it loses power and the car is trying to cutt off and then when I get to traffic light it stalls, and I had to press lock and unlock again before I could crank, not sure if same problem as you but I had one of these in the glovebox.

Posted Image

Took that out and problem is gone. Hopefully this helps but sorry if it doesnt, hope you find the solution soon mate :)

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

But it dont seem to be running rich at all.

infact everything seems perfect just this damn idle problem Vid will hopfully be up shortly.

just try unplug your O2, it's a 3 sec job to do

HYBRID VL Community Regular

HYBRID VL

Posted
  • Author
Posted (edited)

direct link dunno what i did there soz for sidewayz action.

so what am i looking for when i unplug the o2 sensor?

Edited by HYBRID VL
Got a Pulsar Grand Master

Got a Pulsar

Posted
Posted

I honestly thought sidewayz action was gonna be you tromping it round a corner. :laugh:

That's pretty weird. I'd say when you unplug the O2 you are looking for less of that weirdness and more normality.

With the SAFC2 above, they intercept the Airflow Meter. Perhaps the Airflow Meter is your problem.

Try unplugging the AFM and start it. It won't rev over 2500rpm but should idle. If it's smooth, you found the problem.

Could be DIRTY or contacts could need a resoldering.

HYBRID VL Community Regular

HYBRID VL

Posted
  • Author
Posted

Ok just started my car with the AFM and O2s connected let it run for abit and it started to do a lil idle glitch and then ran good then stalled.

Took the AFM plug out started it ran good started idle glitch didnt stall.

Plugged back in the AFM unplug the O2s and it ran like 600rpm really roughish idle but didnt stall kinda smelt like it was running rich at that point.

Plugged all back in started it and it ran just like before.

Im starting to think maybe the AIC valve alotta people at work have been saying its a common problem with alot of older 90's cars that have built up crap inside the valve and it limits or stops functioning and was told to pull it off and clean it cant hurt to do AFM and AICV at the same time right..

  • 3 weeks later...
HYBRID VL Community Regular

HYBRID VL

Posted
  • Author
Posted

Ok did all the above...about 2 weeks ago started my car last night let it idle NP...

Today went out started it was idling died...started idle die....start idle die..thought id start it and acelerate see if it keeps the revs up and it was like i wasnt even acelerating..so im thinking its more to do with either ignition maybe plugs,coils,Fuel pump or Fuel PSI regulator but i doubt it or AFM still now wen it was dieing and i was stuck halfway down the driveway i jumped out popped it bonnet and unplugged my AFm and then plugged it back in and cranked it started and idled NP...drove it back up the driveway..let t idle NP.

i was reading that if i unplug the AFM and it keeps running then the AFm is stuffed If it dies its working well i unpluged it and it died on me plugged it back in and started NP and ran well.

Maybe ther plug is stuffed or a connection or maybe it is still abit dirty the only other things i can think off is fuel or plugs as honestly im lucky to drive my car once a month i do let it idle in the driveway a few times each week.

Thats due to my truck being my transport all day and wifes subie when im home.

what you guys think AFM ?

i was also thinking about check the ACV again aswell after i cleaned it maybe even just by a new 1.

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

start the car, unplug your TPS connector(s)

see where the idle sits, should be flat at 650rpm.. if not.. adjust the idle screw (in for revs down, out for revs up) then plug back the tps connector(s)

HYBRID VL Community Regular

HYBRID VL

Posted
  • Author
Posted (edited)

nah i dont think it has anything to do with the TPS as it idle ok its just it dies it dont drop idle then die it just dies

BUT..i will check that as it will be 1 more thing off my list.

Edited by HYBRID VL

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      I would just put EBC back on the "I would not use their stuff" pile and move on.
    • Duncan
      What brakes on R34 GTT(Europe)

      By Duncan · Posted

      Can I suggest you try EBC directly again and link them to as many competitor catalogues as you can to show their listing is incorrect, eg https://dba.com.au/product/front-4000-series-hd-brake-rotor-dba42304/ If you have access to an R33 GTST VIN and your VIN, you could also use a Nissan Parts lookup like Amayama to show them the part number is different between 33 GTST and 34 GTT which may get their attention
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      So i got reply from EBC and they just this site where you can clearly see those 296mm fronts on R34 GTT. I send them photos and "quotes" that 296mm are not for 34 GTT and they are too small. But it will be very hard to return them cuz nobody here knows 100% and they just copy those EBC catalogue :-D https://ebcbrakesdirect.com/automotive/nissan/skyline-r34
    • 04-LOOX
      R34 GTR Vspec Garage Sale - All must go!

      By 04-LOOX · Posted

      Hi, is the HKS  Tower Bar still available ? negotiable ? 🤔
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      From there, it is really just test and assemble. Plug the adapter cables from the unit into the back of the screen, then the other side to the car harness. Don't forget all the other plugs too! Run the cables behind the unit and screw it back into place (4 screws) and you should now have 3 cables to run from the top screen to the android unit. I ran them along the DS of the other AV units in the gap between their backets and the console, and used some corrugated tubing on the sharp edges of the bracket so the wires were safe. Plug the centre console and lower screen in temporarily and turn the car to ACC, the AV should fire up as normal. Hold the back button for 3 sec and Android should appear on the top screen. You need to set the input to Aux for audio (more on that later). I put the unit under the AC duct in the centre console, with the wifi antenna on top of the AC duct near the shifter, the bluetooth antenna on the AC duct under the centre console The GPS unit on top of the DS to AC duct; they all seem to work OK there are are out of the way. Neat cable routing is a pain. For the drive recorder I mounted it near the rear view mirror and run the cable in the headlining, across the a pillar and then down the inside of the a pillar seal to the DS lower dash. From there it goes across and to one USB input for the unit. The second USB input is attached to the ECUtec OBD dongle and the 3rd goes to the USB bulkhead connected I added in the centre console. This is how the centre console looks "tidied" up Note I didn't install the provided speaker, didn't use the 2.5mm IPod in line or the piggyback loom for the Ipod or change any DIP switches; they seem to only be required if you need to use the Ipod input rather than the AUX input. That's it, install done, I'll follow up with a separate post on how the unit works, but in summary it retains all factory functions and inputs (so I still use my phone to the car for calls), reverse still works like factory etc.
×
×
  • Create New...