Jump to content
SAU Community

Recommended Posts

Attendees:

1. Cadmoon

2. t5iv

3. HiveFleetAbyss

4. NW007

5. cowdy

6. Cyifly

7. Bodo

8. Shi Pi

9. gts032

10. Kiwi_Phil

11. Kiwi_Phil's +1

12. ARE31

13. B-Boi34 +1

14. Bubbles

15. Tohmez

16. Ralf

17. Bubbles

18. Bubbles' +1

19. Wolfman101

What are you talking about? :whistling:

fixed...he's starting to get old and picky about the spelling :P

Attendees:

1. Cadmoon

2. t5iv

3. HiveFleetAbyss

4. NW007

5. cowdy

6. Cyifly

7. Bodo

8. Shi Pi

9. gts032

10. Kiwi_Phil

11. Kiwi_Phil's +1

12. ARE31

13. B-Boi34 +1

14. Bubbles

15. Tohmez

16. Ralph

17. Bubbles

18. Bubbles' +1

19. Wolfman101

What are you talking about? :whistling:

hhhhmmmmmm why am I on here 3 times ?

does that mean I have to go around 3 times more than everyone else ?

I get the +1 but its up there as 14 &17 aswell ....... :unsure:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...