Jump to content
SAU Community

Recommended Posts

Hey all,

Never thought I would have to do this, but could everyone please keep an eye out for my pride and joy R34 GTT, it was stolen today from Ellenbrook between 3pm and 4:30pm. Highly modified, very recognisable. License plates are 1BKI 810.

Also please keep an eye out for this list of parts, I know how these things work:

Link G4 Plug-In,

Greddy Profec B-Spec II EBC,

Haltech 3 bar MAP sensor,

externally gated Hypergear ATR43 G3,

Turbosmart Compgate40,

1000cc Injector Dynamics injectors

, Plazmaman FFP,

Plazmaman 72mm throttle body,

JJR 3" bellmouth dump/front pipe,

VENOM 5" 100 cell cat,

3" custom Kermit Engineering exhaust,

Walbro 460lph fuel pump,

Continental ethanol content sensor,

GReddy FMIC,

AGP triple core alloy radiator,

stock GTR bov,

custom Pro Fabrications alloy oil catch can/radiator overflow combo with Earls fittings,

Splitfire coilpacks,

HKS fuel rail,

Sard FPR,

Speedflow braided fuel and turbo lines,

Performance Springs valve springs and retainers,

Tomei Type-B Poncams,

HKS exhaust cam gear,

Headtorque custom bronze valve guides,

ARP head studs.

Exedy Ceramic racing clutch,

custom driveshaft.

BC Racing BR series coilovers,

Kazama adjustable toe arms,

front strut bar.

18" Wolf S36's,

factory GTST brake calipers

, RDA slotted rotors F&R,

HEL braided lines,

EBC Greenstuff front pads,

Ferodo pads GTR rear wing,

Top Secret front bar

, custom retrofit projectors,

Sparco R505 racing seats driver and passenger,

Recaro seat rails,

ARK Design MFD

, Zeitronix ethanol content analyzer,

AEM wideband,

4x Shadow Pro series gauges,

custom carbon fibre bits.

PLEASE PLEASE, if you see it or hear anything, call the police or me on 0431047984.

I don't hold much hope of getting it back in one piece, but it's a very recognisable car with very recognisable parts, so I'll give it a shot.

Link to comment
https://www.sau.com.au/forums/topic/435962-car-stolen-from-ellenbrook/
Share on other sites

Brick through the window, keys were hanging on the hook. I'm sure they were casing the place because I am home 99% of the time. I went out for an hour to pick my girlfriend up from work, came home to this.

Seriously regretting not getting a GPS tracking system. I was so close, then decided I was being paranoid and my car was never gonna get stolen.

Just to let everyone know, my car was just found dumped, thankfully in the same condition they took it. Nothing been taken off the car, and on initial inspection doesn't look like there's any damage. It's been towed to forensics tonight and I should get it back tomorrow arvo. Going to get it towed straight to my tuner for a full mechanical check before I drive it anywhere.

But to everyone that helped in sharing it, thank you so so much. It was through the 'Perth Crime Reports' Facebook Page that someone recognised the car and gave me a call. Can't even describe how much it means to me.

  • Like 1

Just to let everyone know, my car was just found dumped, thankfully in the same condition they took it. Nothing been taken off the car, and on initial inspection doesn't look like there's any damage. It's been towed to forensics tonight and I should get it back tomorrow arvo. Going to get it towed straight to my tuner for a full mechanical check before I drive it anywhere.

But to everyone that helped in sharing it, thank you so so much. It was through the 'Perth Crime Reports' Facebook Page that someone recognised the car and gave me a call. Can't even describe how much it means to me.

f**k yes man!!!

good to hear!!!

Atleast someone called up about it!!

Makes me paranoid now :S, even though mine looks nowhere near as good as yours, still makes me think twice about it.

( my brother nearly got car jacked last week in glendalough :(, luckily my bro grabbed the keys before they noticed after he ran off with his GF. )

He also has a r34....man so many 34s being stolen...

A White GTR was stolen last night aswell..prob same peope...

Holy crap, I only just noticed this thread. So glad to hear you got your car back mate in one piece but also sorry to hear that you had to go through the ordeal of having your pride and joy stolen :O I've had it happen once before and it's not good :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...