Jump to content
SAU Community

Tial 44Mm External Gate & Toyo R888 245/35/18

robbo_rb180
 Share

Recommended Posts

robbo_rb180 Grand Master

robbo_rb180

Posted
Posted

Tial 44m gate with 14psi spring $300- used for a few dyno runs and removed. comes with flanges and some pipe

toyo r888 245/35/18 $350 ono - have been used for a few sprint days, tread ranges from 3.78mm to 4.75mm is the worst and 4.2mm to 5.5mm is the best

located in wodonga, victoria

will post tial gate, pick up only for tyres

call O439 782 582 do not text i will not reply

post-60041-0-92281000-1387232127_thumb.jpg

  • 1 month later...
Joshbigt62r Proficient

Joshbigt62r

Posted
Posted

Hey Robert,

So your after $200 for a set of 4 r888's pickup?

How old are the r888's? Would they be roadworthy?by the tread depths at a guess there would be 5000 odd km's left in them?

Im also just down in Wang.

Cheers Josh

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      I'll get one of these also just for giggles
    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • feartherb26
      RB25DE NEO with Haltech ECU

      By feartherb26 · Posted

      If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • Kinkstaah
      RB25DE NEO with Haltech ECU

      By Kinkstaah · Posted

      This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • Murray_Calavera
      RB25DE NEO with Haltech ECU

      By Murray_Calavera · Posted

      I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
×
×
  • Create New...