Does Anyone Have A Spare Dba954 Rotor Lying Around?

[warps]

Looking for a DBA954 rotor to take measurements off, or to borrow for trial fitment for a brake upgrade on a track car (not Nissan). Doesn't matter to me if the rotor is new, old, warped, cracked, rusty etc as long as it's intact and roughly the same shape as originally intended. The DBA website doesn't give all the measurements I need, and I'd like to confirm actual dimensions before buying a set and finding they don't suit my needs (already have a pair of rotors that were perfect on paper, but don't quite suit what I want).

The rotor in question is fitted to the front on the following vehicles:

• V35 Skyline 350GT: 2002 - 2007
• M35 Stagea: 2001 - 2007
• 350Z Touring model: 2003 - 2005
• J31 Maxima / Cefiro: 10/03 onwards

If you have one of these rotors you'd be prepared to loan out or take some measurements for me, then I would be forever in debt (well, until I forget about it, anyway).

TIA

[PN-Mad]

Location?

[GeeDog]

I've got a set of RDA954S in the shed - what do you want to know about them?

[warps]

Location?

gold coast

I need the thickness of the mount flange, and inside diameter of the mounting face ie the biggest diameter hub flange the rotor will fit over. I can do up a sketch in the morning to confirm the exact measurements I need to clarify

[PN-Mad]

Meh, bit much to ship one.

Give me a generic pic/ sketch with the dimensions you want and I'll be happy to measure it up for you.

[warps]

Thanks. Will prepare a sketch in the morning.

[GTRPSI]

954 Specs....i have them in my listing below in the item description.....

http://www.ebay.com.au/itm/DRILLED-SLOTTED-Nissan-350Z-Z33-V6-Touring-03-FRONT-Disc-brake-Rotors-RDA954D-/131106764705?pt=AU_Car_Parts_Accessories&hash=item1e869277a1

Hat height is the total face to rear of the rotor height.

Lay it on a table like a hat, measure through the hub hole from the table to the top face that the wheel sits on.

Hope that helps you...

[warps]

Thanks but I already have the dba catalogue with those specs. The dimensions I need aren't listed in the catalogue.

out of interest how much would you charge for the plain version of those rotors (ie not slotted or drilled - I don't need the bling). Pm me if you prefer.

[warps]

These are the dimensions I'm after

F.T. is flange thickness (preferably to within 0.5mm or better)

I.D. is the inner diameter of the mounting flange

[PN-Mad]

[PN-Mad]

[warps]

Thanks PN-Mad and many internets to you. I'll buy you a beer next time you're up this way.

The flange thickness is spot on, but I fear the 144mm ID may be too small for my needs. I'll head down to the shed later today to confirm. Fingers crossed

[PN-Mad]

No dramas mate, happy help out.

[GeeDog]

on the RDA rotor the ID tapers from 144 down to about 142.5 near the flange - as good as I can measure

[warps]

Dammit! The hub is 146.5 diameter. I was happy to take a 1mm cut off the hub flange bit that might be getting too much.