Jump to content
SAU Community

Recommended Posts

hey guys i am having a problem with my car, the issue is my car won't start

like when i try to turn the key over there will be no cranking what so ever,

i thought it would be the battery so i gave it a jump start but nothing happens

the interior lights seem to still work as well as my break lights, but nothing else works

the dash light would work until i turn my key over to accessories and then it'll die with no dash light

its as though the immobilizer has activated :S, its happened a few times, the first time i managed to fix it by

taking of the positive terminal and put it back on after a while, the second time it happened i tried the same thing

but it didn't work and so my friend was checking out the fuses to see if it's loose and it seeemed to work

but the problem came back, i was wondering if anyone else has experienced this? if so what did you do to fix or? or what could be the problem?

Link to comment
https://www.sau.com.au/forums/topic/446376-car-not-starting/
Share on other sites

I've never had this problem with my 350z, but I had it with an older car (a ford laser) and it was simply a dead starter motor.. Are you getting any noise at all when you turn the ignition to start?

Going by your previous experience it's probably more likely to be related to the immobiliser - maybe your previous fix didnt actually fix the problem properly, only temporarily..?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...