Jump to content
SAU Community

Recommended Posts

I wish to know where to buy the above items, M10 fine thread. Aka Crown lock nuts, partial torque, uni-torque, Grover, Auto, Automotive, Elliptical offset to name the descriptors that I have found so far. (Flanged or non-flanged).

I have searched the net & SAU in vain to find an Australian supplier or source reference. Can buy by the 100cwt., out of China lol.

Or ; Does anyone have a part number for OEM Nissan M10 X 1.25 cone lock nuts or flared cone lock nuts? That could work.

Yes I could use spring washers or nylocs but would prefer same as what was present on my suspension if possible.

Thanks for reading.

GW

Toyota exhaust nuts - m10x1.25 thread. Have a look and see if they're what you're talking about (sounds like they are). Used on a few different engines, definitely on the 3sgte's. Get them from any toyota parts dept, and cheap enough.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If there's enough meat in the housing where you want to put the M12 adapter, then do it, but be aware that if/when you f**k that up you'll probably be repairing it before doing anything else. I'd just drill it out and tap ina 1/4" thread. No need for rocket surgery when the next most obvious thing will do. You could throw a 1/4 x 1/8 bush in there and use the same fitting you intended to use.
    • Is the only issue that the oil catch can is getting filled on hard runs? I'd be thinking more about oil control issues rather then the head lifting, especially as you aren't seeing spiking in the coolant pressure.  Do you need restrictors in the head, or better drains from the head? Does the sump need venting to the catch can?
    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
×
×
  • Create New...