Jump to content
SAU Community

Recommended Posts

Hi guys i have a 2000 gt-t r34 skyline.. the car starts every time no probs when cold, but after driving it a while when i go to restart it wont, just keeps turning over.. but this does not happen all the time,

i have been told it could be the ac sensor but im not sure thats right as if it goes it wont start at all? could it be coils? or perhaps a water temp sensor? as i said it doesnt happen all the time so its hard to pin point the problem... any feed back would be awesome ty

Battery is new... and winds over fine just wont fire... if i keep trying to start it the battery will go flat naturally which i did before but when i tied it up to jumper leads it fired up.. the **** who put the battery in before i think has the wrong one as the terminals are too small for the battery and the *** bashed them on squashing the terminal on the battery a little... but like i said it starts fine when cold every time..

The temperature sensor in the bottom of the radiator is only used to switch on the condenser/overheat fan that comes in when your coolant temp is at 94 degrees.

There are two other sensors located on the plenum/water inlet. One is a single wire coolant temp sender, which is used for the temperature gauge. And the other is a two wire coolant temperature sensor, used by the ECU.

What you need to do is isolate the problem. When it's hot and cranks but doesn't fire, does it have spark, injector pulse, fuel pressure? If you can determine these you will be able to pinpoint the problem. Eg Fuel pump, crang angle sensor, ECU etc.

Good luck.

  • Like 1

Cool thanks, the only reason I asked is because my idle control feked up and for ages I couldn't figure out why. Car ran fine at start up then hunted once the loop changed

.. When I pulled the radiator the wires to that sensor were worn through.. Hopefully this fixes when I start her in a couple of weeks

Of topic but yea

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I refreshed the OEM injectors with the kit and connected it up. It now ideals okay even with the IACV removed. Driving still has the same cutoff issue like the 550cc injectors so the issue is somewhere else. I bought FPG's Fuel Pump Hanger. I will be installing it next, but it is not as straightforward as I thought it was with my limited wiring knowledge and no instruction on the specific model I purchased (FPG-089). I also got the incorrect billet clamp as I could not find info on the OEM sizing.
    • Stop looking at the garage floor, and turn the radio up a bit louder if there's any strange noises...
    • No. Turbo shuffle and surge/flutter are not the same thing. Specifically, on a GTR, turbo shuffle has a definite meaning. On a GTR, the twin turbos are assumed to be the same thing and to operate the same way, exactly. In reality, they do not. Their exhaust sides are fed and exhaust a little differently, to each other. Their inlet sides are fed and exhausted a little differently, to each other. Consequently, when they are "working" they are often at slightly different points on the compressor map compared to each other. What this means, particularly when coming on boost, is that one of them will spool up and start producing extra flow compared to the other, which will put back pressure on that other compressor, which will push the operating point on that other compressor up (vertically). This will generally result in it bumping up against the surge line on the map, but even if it doesn't, it upsets the compressor and you get this surging shuffle back and forth between them That is "turbo shuffle" on a GTR. It is related to other flutter effects heard on other turbo systems, but it is a particular feature of the somewhat crappy outlet piping arrangement on RB26s. There are plenty of mods that have been attempted with varying levels of success. People have ground out and/or welded more material into the twin turbo pipe to try to prevent it. Extending the divider inside it works, removing material doesn't. There are aftermarket replacement twin turbo pipes available, and these exist pretty mush purely because of this shuffle problem.
    • You can temporarily* use lock collars to keep it in place until you can do the bushes, back the nuts off, slide them in, snug back up. *temporarily is often for ever
    • Thanks for the quick reply. To be clear, when you say turbo shuffle do you mean turbo flutter "stustustu" or referring to something else? I had thought they were the same thing. When I wrote the post my intention was to say it wasn't a flutter/compression surge sound. My understanding was that a flutter sound would be occurring when throttle is released, whereas I can keep the throttle in the same position for this noise
×
×
  • Create New...