Jump to content
SAU Community

Recommended Posts

So I'm thinking of getting this, transplanting the necessary parts into the YOLOdeo and selling the rest, thoughts?

(Yes, I know I should have bought that S13 off of Corey)

nEtay2W.jpg

  • Like 1

Work tomorrow morning, got a BBQ or some shit on Sunday. I'm pretty broke this week so going to try and keep things fairly tame.

Might watch the footy tonight.

What about yourself?

Posts just came back

Fishing local sun morning with friends, painting and stuff at home. Pretty much finished all jobs at the block for a while, bobcat can have a rest for a couple weeks

beard meeting?

Of course! His was looking slightly more spectacular than mine though :P

Soooo, farken cars. Drove the hairdresser brap into work today, was giving it some berries along Wanneroo road, hit boost cut and then my zorst started sounding grumbly and shit. I looked under the car and on idle the zorst is coming out of the screamer pipe and not the back of the car, arghhhh! Guessing my gate is stuck open or something.

So that's sitting in the workshop and is Tuesday Hank's problem :(

Broken spring in gate maybe?

Quite possibly. That's what you get for fitting the finest purple Chinese wastegates I suppose :P

Might have to splash some cash for a proper one pending inspection, I'd rather not but you gotta do what you gotta do.

Hey Kent's. Big 24hrs. Went camping out bush over night, rushed back for fishing and lunch on beach with friends. Now couple jobs at block then go home and tidy up the van etc.. Gonna need more beers later to help recovery




  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...