Jump to content
SAU Community

R32 Gts4 Gozilla For Sale

Godzara
 Share

Recommended Posts

Godzara Rookie

Godzara

Posted
Posted

Built to be a godzilla. Got it as a swap but dont actually want it. Need money.

Evo 9 brembos and rotors ,

rb26dett ,

r32 gtr gearbox ,

350z wheels 18x8 +30 ,

4 inch cat back ,

gtr 4piece widebodykit ,

gtr spoiler ,

carbon fibre n1 boot lip ,

after market rear tow hook ,

turbo timer ,

rb26dett conversion ,

sparco quick release ,

NRG boss kit ,

projector headlights ,

gtr reo ,

gtr n1 bumper + oem lip ,

splitfire coilpacks ,

stock gtr twins ,

dmax

vented bonnet ,

gtr guards ,

drift steering wheel ,

excedy hd single ,

Hks coilovers,

Gtr indicators ,

fresh paint job

All oils and fluids are brand new. Motor does need to be tuned and run it. Txt 0417773691 if interested. Currently at wotk so will reply when i can.

Looking for $17k ono

post-134862-14326891324833_thumb.jpg

post-134862-14326891555042_thumb.jpgpost-134862-14326891820466_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/456977-r32-gts4-gozilla-for-sale/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...