Oil Pres Sender 2 Pin To 1 Pin Convert..

[Paulusc44]

A31 Block in R32 Chassis.. R32 Dash has Oil Pres Gauge + Low Pres light.. A31 Dash only has Oil Pres Gauge..

R32 has 2 wires (Yellow+White, Yellow+Blue) A31 Oil pres sender only has 1 pin.. So.. Which wire is for Oil Pres and which wire is for the Low Pres Warning Light?

My plan is to simply slide the pin which is for the Oil Pres onto the A31 Oil Pres Sender and then either earth the remaining wire or run it to 12v?? Still unsure..

Dont want to swap sender units as I know this can be done, found forums a while ago but have lost them

Cheers

[GTSBoy]

Get the R32 GTR service manual pdf off your uncle Torrence and look at the RB2 engine wiring diagram which is in the back after the RB26 stuff.

True story.

[Paulusc44]

Get the R32 GTR service manual pdf off your uncle Torrence and look at the RB2 engine wiring diagram which is in the back after the RB26 stuff.

True story.

Ahh haha I dloaded that a while back.. was having a look at it last night and thought Id be cheeky and try to save myself 20 mins.

Are you absolutley sure this is a true story?

[GTSBoy]

No it's not true. It was meant to say "RB20 engine wiring diagram".

Bloody typos!