Jump to content
SAU Community

Recommended Posts

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

Hmmm I take it you have never been to the Ministry of Sound raves huh Joe:rolleyes: :)

Yeah if ya coming from the north just go down the freeway till ya hit Graham Farmer Freeay then just after the pipe i think 2nd or 3rd exit not only will you see it from there but there is some nice blue signs to help the oldies find their way to the track to bet their pensions :-) but could come in some good use for you! :)

Can't miss it really..... Nice big carpark for motorkhana so that should be good!

Originally posted by skyzerr33

25GTT so your in the Rollaboys display? should make you easy enough to find.

Yup! I think I am next to ND4SPD and R7X... just got plates made up for the show aswell.....

check the writing on my avatar and thats what it is! well i thought it sounded cool....I could be wrong though :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...