Jump to content
SAU Community

Recommended Posts

Road tuning, I need a mentor

Hello, finally got my rb30 running. It was definatly worth it. Boost comes on earlier etc. still thinking about running 8cm rear housing cause there's not enough tourque for me. It's got plenty of power don't get me wrong. Ive got a feeling it has to do with timing comming on to boost .I'm currently road tuning. Found a copilot so I don't have to think to much. 

Link to comment
https://www.sau.com.au/forums/topic/468382-road-tuning-i-need-a-mentor/
Share on other sites

I changed it last night. Took it for a drive to day. It's everything I've been wanting and more. It spikes to 20psi then dies down to 15.  it spins the wheels in 1 2 3. 

I'm so much happier with every charictoristic. It's got 5 psi at 3000

I was never looking for over 300kw just tourque.

i hated the 25 with 10cm. The 30 with 10 cm was ok. But with the 8cm it's like a v8

im going to sell it now and get my dream car. An r32 gtr completely stock with a 3.4l

It wouldn't be stock then would it lol. Hope you have deep pockets my friend with the cost of a 3.4L and R32 gtr's at the moment.

On topic, road tuning is not easy and is a time consuming process to fine tune maps. I hope you have the right equipment at your availability so you don't do damage.

Yes. I agree, with everything u say, especially the tuning. I'm scared my afrs are lean on boost transition especially when I'm not full throttle. Full throttle is 11.7 but leading up to that seems a lot lighter if I'm moderating the throttle. That's somthing I'll address in the next drive to keep it safe. I'm keen to get some ears on to listen to knock aswell before the next drive. If there's one thing I know it's I have no idea what I'm doing..

as for the over oiling thing I think I've got that covered. After a total of 3 hours of reving to the limiter I've collected 200mm of oil in my catch can. Easily eliminated by running a t piece to the turbo drain.

Better to put more fuel in and take it out later to be safe than lean out and destroy a motor. What sort of ecu do you have? Knock ears and equipment isn't cheap just as a FYI. Also what sort of wideband are you running?

Plenty of variables to consider, if you are really keen I'd suggest getting stuck into tuning forums and doing plenty of research to further your knowledge on tuning. Tuning a full throttle run is quite easy to do and takes minimal effort but getting a perfect map for different load points will take time and patience.

As a side note, 200ml (if that is correct) is a massive amount of oil to have collected in the catch can even if you are bashing limiter for 3 hours (not sure why you need to be revving to the limiter constantly either).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...