Jump to content
SAU Community

Recommended Posts

Buy front 350Z Brembos and use 350Z Discs.. works out cheaper, uses the same brake pad as well DB1520 or IN1520 when referring to Intima Brake pads.

Unfortunately the rears don't fit.

Buy front 350Z Brembos and use 350Z Discs.. works out cheaper, uses the same brake pad as well DB1520 or IN1520 when referring to Intima Brake pads.
Unfortunately the rears don't fit.

Hi will it be a straight bolt on or needs an adaptor.

It's not Facebook so you get proper answers here, with experience and evidence supplied :)

Straight bolt on for R34s, R33/32 you need to enlarge the mounting hole to 14mm from 12mm.

http://www.trak-life.com/diy-350z-brembo-brakes-conversion-nissan-skyline-r33-gts-t-gts-gts-4/

  • Like 1
It's not Facebook so you get proper answers here, with experience and evidence supplied [emoji4]
Straight bolt on for R34s, R33/32 you need to enlarge the mounting hole to 14mm from 12mm.
http://www.trak-life.com/diy-350z-brembo-brakes-conversion-nissan-skyline-r33-gts-t-gts-gts-4/

Thankyou so much mate really appreciate it.
  • 3 weeks later...
Hi FYI I have a full set of evo 7/8/9 brembos for sale, I am not sure if thats suitable for your GTT tho.

p.s. Johnny/Trak-life's info is also very accurate/reliable :1310_thumbsup_tone1:

This will adaptors and hence certification..
  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...