Jump to content
SAU Community

Recommended Posts

Round 5 - Winton 13th August Hosted by WRX Club

596abe0e3da83_Round05.jpg.e45976a2df456dc189dc6b7079accd41.jpg

Round 4 Winton Sunday 13 August 2017 

Entries $205.00 (using our affiliate code)  O0GVZ12G

Late entries will be $220 after the 3rd of August

Entries close 9th August

Spectators free.

Supp regs, and further details can be found on the WRX entry page by following the link below

http://www.wrx.com.au/event-2598083  enter affiliate code O0GVZ12G

 

  • Like 1
  • 3 weeks later...

Ok here is a link to the pics taken by @(O)(O)SKYLINE(O)(O)

Well done to Sam on a massive PB and fastest car on the day by a mile. I hope everyone else who came out enjoyed themselves.IMG_0466.thumb.JPG.c85c25fcdfa7263f4bd2682a5122b2a2.JPG

Capture1.thumb.PNG.94e4bd262fad6afb6c8fd6e3de98a7a6.PNGCapture2.thumb.PNG.140b6c461bf26d2ec48bb29928dd4061.PNG

  • Like 1


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...