Jump to content
SAU Community

Installing 1000HP ati balancer on RB26. stock crank bolt or ARP version?

burn4005

By burn4005,
in Forced Induction Performance

 Share

Recommended Posts

burn4005 Proficient

burn4005

Posted
Posted (edited)

Hi Guys,

I'm going to be installing an ATI 1000hp balancer this weekend on my ~800 flywheel horsepower RB26 has a steel trigger wheel welded to it adding about 600 grams. will torque to 450Nm with oil as per manual, is the OEM nissan crank pulley bolt the correct option for this damper or should I be using an ARP (102-2501) version?

cheers

Edited by burn4005
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      R32 non hicas power steering solenoid issues!

      By GTSBoy · Posted

      Yeah, alright, I take it back. I hadn't bothered to compare the terminal numbers - they're not the same. I was working on the presumption that it was the "small plug" half of the HICAS CU because it has the same plug as the small plug on the HICAS CU. And...the drawing says "Refer to Super HICAS system circuit diagram" which seemed to place it firmly in the world of HICAS, not non-HICAS.
    • joshuaho96
      98 ER34 GTT idle races, if AAC is unplugged, then idles perfect

      By joshuaho96 · Posted

      You definitely have a big problem if with the adjustment screw closed up you're idling at 1200 rpm. Have you verified you have no vacuum leaks? No throttle shaft seal leaks? Nobody has messed with the throttle body set screws? I would love to see what Consult reports when your engine is idling that high.
    • joshuaho96
      R32 non hicas power steering solenoid issues!

      By joshuaho96 · Posted

      HICAS has a much more complicated circuit diagram, for some reason the R32 GTR service manual discusses both. The HICAS module has proper 2 way communication over consult, the "EPS control unit" doesn't have any of that and only exposes a raw analog voltage for the EPS solenoid valve. It's ultimately mostly about speed sensitive steering but the non-HICAS unit also looks at the neutral switch/brake/clutch switch to adjust how it provides assist.
    • No Crust Racing
      R32 Gtst - Track Car

      By No Crust Racing · Posted

      I'm still negotiation Aus Time attack which falls on my wife's birthday weekend...
    • GTSBoy
      98 ER34 GTT idle races, if AAC is unplugged, then idles perfect

      By GTSBoy · Posted

      Yeah, that doesn't necessarily mean that it flows. If the exit side pipework is blocked somewhere (in the hose, in the nipple that it returns into the motor/plumbing, etc), but the supply side is not blocked, then when you crack the bleeder you will get flow from the open side. But when you close the bleeder - no flow. And.... therefore no heat. You might have to work a little harder to prove it to yourself. When I bought my engine the entire IACV bleeder was choked with cooling system schmutz. I had to clean it and the pipework out before it would work.
×
×
  • Create New...