Jump to content
SAU Community

Recommended Posts

I've always had a slight whine in 4th and 5th in my R33 Gtst 5spd but lately it's turned into a full blown dog box whine under acceleration. It varies a little with throttle and load but for the most part it's always there whilst driving. Is there a recommended transmission rebuilder for these gearboxes to take it to in Melbourne? What sort of parts am I looking at and is it likely to happen again due to power level or is it a wear issue?

Link to comment
https://www.sau.com.au/forums/topic/475382-making-dog-box-sounds/
Share on other sites

My old boat would do this, 900ish nm and sticky tyres would chew up the stock boxes real quick.

I even had a good shop (award) rebuild it twice.

The poor old boxes are well past their OEM torque specs when the power goes up.

Flooging the hell out of them doesn't help the situation, but then why make the power and not use it in anger.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...