Jump to content
SAU Community

Recommended Posts

Engines misfiring. Its okay when it first starts but then just gets worse. 

Ive replaced spark plugs, leads, fuel filter. Cleaned fuel injectors aswell as new pintle caps and baskets. Ive cleaned out the intake aswell. Injector wiring harness is okay ( im going to test everything else as i just bought a multimeter yesterday) 

Injector plugs receive voltage and injectors all have 2.5ohms of resistance. Repair manual says spec is 2.3ohms but i dont think thats an issue. 

Enlighten me ???

Link to comment
https://www.sau.com.au/forums/topic/478335-rb30-misfiring-ausdel-r31/
Share on other sites

@GTSBoy

Dizzy cap is fine, as for the flanges inside it, how worn is worn? 

Compression is fine so i dont think itd be a cracked head... 

Im checking the rest of the electrical components tonight and im also replacing ecu with a spare i had laying around

Remove distributor, remove rotor, remove metal plate behind it.

Crank angle sensor (CAS) is in there. You may notice some crap on the disk. Very carefully wipe it down.

Re-assemble, set timing properly, save up for new CAS/bearing/etc

Step 0: read this https://wiki.r31skylineclub.com/index.php/Crank_Angle_Sensor

  • Thanks 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...