Jump to content
SAU Community

Recommended Posts

After a few hard brakes and some spirited driving in the gtst, i was cruising down a street and went to hit the brakes and there was nothing there!! The pedal went all the way to the floor, i pumped them then it sort of came back then there was nothing. I left the car at home then the next day went for a drive and everything is perfect again? Though i am feeling very uneasy about braking atm after what happened. Any ideas would be greatly appreciated!

Some of my thoughts:

Brake master cylinder is on the way out?

Brake fluid is crap?

Brakes need to be bled?

Link to comment
https://www.sau.com.au/forums/topic/51141-whats-wrong-with-my-brakes/
Share on other sites

I would guess that you more than likely need the brakes bled and get new fluid. Sounds like you current brake fluid has absorbed a fair bit of water and is boiling really easily, as the spongy pedal is the main symptom of overheating fluid. Don't know what you currently use, but it might be worth upgrading to something like a DOT 5.1 fluid or something along those lines.

If that doesn't fix it, then have a better look at other possible problems.

Cheers,

Jae.

If you have cheap brake pads on it and you were driving hard you may have heated the pads up past their working temperature causing them to lose there resistance which would explain why they worked fine afterwards,(they cooled down) this happens a lot when the pads are low aswell, i dont think it would be the master cyclinder, check for leaks anywhere on the brake line or the master cylinder though.

Thanks mate, i will bleed the brakes the following weekend and change the fluid.
My suggestion would be to take it to the best brake mechanic in your area and explain what happened. You are best off getting new brake fluid (which involves getting them bled). I spent ~9mths with a very bad brake pedal and driving was no fun. It cost well over $2,500 in total, I got everything fixed/upgraded because the feeling of having no brakes is the worst and I was happy to spend money to ensure it doesn't happen again.

Once your fluid has boiled, replace it.

I boiled/cooked my brakes so badly after literally 2x 10 lap sessions (very average speed laps too) at Eastern Creek that it destroyed my brake system. Pedal went to the floor, pumping it did nothing, had to limp home and it basically spent the next week at a workshop and took more than 5 mechanics and ~9mths of mucking around to get the problem solved.

Good quality DOT5.1 will cost about $100 and an hour of their time. Depending on how much damage you have done you may also require new brake pads which could be around $200 all up.

It's fun hitting boost and watching that speedo increase rapidly, it's not fun watching the car infront get closer and closer with your foot already firmly on the pedal.

Sounds like you cooked the brakes. Better pads and fluid should fix it.

The same thing happened in my previous car, which was caused by a faulty handbrake. The master cylinder followed soon after :) It had a similar feeling under the pedal but a lot more expensive to fix.

After a few hard brakes and some spirited driving in the gtst, i was cruising down a street and went to hit the brakes and there was nothing there!! The pedal went all the way to the floor, i pumped them then it sort of came back then there was nothing. I left the car at home then the next day went for a drive and everything is perfect again? Though i am feeling very uneasy about braking atm after what happened. Any ideas would be greatly appreciated!

Some of my thoughts:

Brake master cylinder is on the way out?

Brake fluid is crap?

Brakes need to be bled?

I reckon you should take another driving test?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...