Jump to content
SAU Community

Recommended Posts

Well it's illegal to remove a factory fitted airbag system, plus there is some minor danger involved in removing it, been known to cause a few broken noses etc. Luckily mine had already been done before it landed here:D

Hey Alan,

Hope your enjoying the Skyline :burnout:

Personally I like the standard steering wheel that comes with the R33, not as bad as some local cars (cough Commodore cough).

Getting it re trimmed might be a safe option.

Never knew it was illegal to remove airbag steering wheels though?

Dude

Most wheels will be interchangeable with the same manufacturer

I stuck a evo6 wheel on my satria.. airbag to airbag. mistubishi essentially.

It worked fine....same goes for swapping an s15 or a gtr wheel etc..

just make sure that the battery is disconnected etc

no explody

Hi mate - Very cool car, very happy with it. Spoiler Shop has it at present - New Bomex front end had trouble finding anyone with the GTR Front in stock.

Adding in the white dials as well ( I like those :elaugh: )

Back to Cypher next week for some Apexi Pillar Gauges and new sound system fit and off we go again. Must be mid life crisis hahahahaha

Thanks for all the advice guys, all of you.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok guys thank you very much. GCG highflow it is then 🙂 
    • forgot to mention that when it does this it does not kill the engine, but I have not kept the pedal down long enough to let it, as I see no reason to beat up on it as its got to be something simple, small and dumb causing this.  And as soon as I let off pedal, the engine returns to its normal super smooth operation and rpms re-stabilize quickly, once below 4k. 
    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
×
×
  • Create New...