Jump to content
SAU Community

Recommended Posts

Speed magazine said it's pronounced Stayjah.

We all know how reliable the info in magazines is :D

I've always pronounced it Stay-jee-ahh.

As long as people know what you're talking about, then I don't think it matters all that much.

Link to comment
https://www.sau.com.au/forums/topic/55590-pronounciation/#findComment-1083323
Share on other sites

Hahahaha rofl if someone asks me what a stagea is ill tell them its a Skyline Turbo and Gearbox Wagon ;)

Thats Gold :)

I looking at the japanese characters for Stagea they can be broken down to 'Su' 'Ta' 'Ji' 'A' which to me sounds like Sta Gee Aaah

Link to comment
https://www.sau.com.au/forums/topic/55590-pronounciation/#findComment-1083405
Share on other sites

I looking at the japanese characters for Stagea they can be broken down to 'Su' 'Ta' 'Ji' 'A' which to me sounds like  Sta Gee Aaah

So "ji" is pronounced with a hard "j" ?

Sta Gee Aaah

or

Sta Jee Aaah ?

....still no less confused yet :)

Link to comment
https://www.sau.com.au/forums/topic/55590-pronounciation/#findComment-1083409
Share on other sites

"STAY..........GEEE.............AHHHH"! is how my parts guy in Japan calls it dont start me on Subaru.

I had to laugh,

but HPI also pronounced it Stay-jah as well (possibly a bit more reliable than Speed ?)

We know what HPI is like and half the writers for SPEED write for HPI so no need to coment either way.

Link to comment
https://www.sau.com.au/forums/topic/55590-pronounciation/#findComment-1083432
Share on other sites

I'm confused. i don't know how to pronounce my cars name. some people say it differently all the time.

is the 'g' pronounced as in Gorilla, or as in Germany?

I believe it is pronounced 'Stay-Jah'- Correct me if I'm wrong, but it sounds right, and I have hears others say it like this aswell

Link to comment
https://www.sau.com.au/forums/topic/55590-pronounciation/#findComment-1083588
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...