Jump to content
SAU Community

Recommended Posts

Hello all, I've just purchased a spotless 97 Stagea and am trying to decode all the electronic buttons on the inside. (I've flown planes with less buttons in the ****pit than this). I've found a turbo timer under the dash that was installed prior to import and as the battery died on the way over, it now needs programming. Unfortunately there is little to identify it other than the following:

"Linear full auto turbo timer 125" writ across the top of the 4 digit red L.E.D. display.

A serial number z023641

6 buttons labelled Power, auto/manual, min/sec,set, up, warm.

Then "Battery" and "min/sec" writ under the LED display.

Its Black and small and flashes numbers at me randomly while driving and then insists on idling the motor for 30 seconds after shutdown regardless of driving conditions.

Anybody know who the manufacturer is and if so - anybody got a manual or programming guide?

Thank you all.

Link to comment
https://www.sau.com.au/forums/topic/62026-what-turbo-timer-is-that/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...