Jump to content
SAU Community

Recommended Posts

u could try the join in baysie i went to a couple of years back for the 31 .. prolly still there. They had great prices on the window, they can prolly get the seals too..

just near the railway tracks along scoresby rd..

you could give Custom Cut a try. dunno prices really but we do a lot of general glass trade with them, they do a lot of car windows etc as well.

otherwise just listen to what that queenslander has to say :( that might be closer to you as well (or custom cut might not come out that far? i dunno)

hope your car wasnt out last night :rofl:

Hey dude i would give a joint called "Roy's Windscreens" a call hes a top bloke did an awsome job of fixing mine when it came off..

Number: 0417323115

He's very fair and does a good job you may have seen his van around it's bright orange good luck hope he can possibly help you out.....

y

hope your car wasnt out last night :(

It was out yesterday... and when i got to the car the drivers side floor was covered in water :rofl:

Mavric, thanks for the contact, I called Roy and he is really helpful. Gonna get him to check it out. He is going to pull everything off, do a compression test and find whats causing the leak and he told me worse case scenario will cost $66!

Much better than Obriens and their BS

Thanks

no worries dude hes a top bloke tell him the dude wif the Yellow R33 reccomended u to him when he comes around he shoudl remember me lol my car aint one u would forget...

take it easy hope he works it all out for you...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...