Jump to content
SAU Community

Recommended Posts

Anyone know how many points you lose if you get caught in a bus lane? would you even lose points?!?!

also, how long are you allowed in a bus lane? say if you were turning left at the next intersection/side street/etc, how long can you drive in the bus lane before you get to the point you turn off?!!?

thanks!

Link to comment
https://www.sau.com.au/forums/topic/69424-bus-lane/
Share on other sites

f you are fined for driving in a Bus Lane you will incur 3 demerit

points.

Bus lanes are for buses, but also can be used by taxis, hire cars,

vehicles operated by or under direction of the RTA, bicycles and

motorcycles. Other vehicles may only enter a bus lane 100 meters

before turning.

Link to comment
https://www.sau.com.au/forums/topic/69424-bus-lane/#findComment-1288549
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...