Jump to content
SAU Community

installing a boost tap on an rb20det

dave_rb20
 Share

Recommended Posts

dave_rb20 Enthusiast

dave_rb20

Posted
Posted

Hi guys,

Can anyone describe which hoses I need to use (mspaint pics would be awesome :Oops:) and which way the arrow should point..

Also is 12psi ok with 3" turbo-back and the factory sidemount?

Thanks heaps

-dave

Link to comment
https://www.sau.com.au/forums/topic/70979-installing-a-boost-tap-on-an-rb20det/
Share on other sites
Cubes Grand Master

Cubes

Posted
Posted

12psi is fine on a RB20DET with the stock IC.

Be sure that it isn't leaning out.

This will require a dyno power run, can be had for as cheap as $35 up to around $50.

The arrow points in the direction of airflow. So towards the actuator.

Pop the bonnet. There is only 1 hose. :)

Cut it in half and shove the bleeder in the middle.

If the hose is a little short (which it will be) grab some more from the auto store and connect it up. Very easy. On the Rb20DET's at least.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • blind_elk
      Wheel refurb?

      By blind_elk · Posted

      The powder coating came in at $250 EACH. The TRX rims got a coat of clearcoat on the outside only.    
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Bit wet, but YUMMY
    • GTSBoy
      Pops when backing off throttle, rough-ish sound through rev range.

      By GTSBoy · Posted

      Keeping in mind that I am currently getting flat 10 L/100km on my RB25DET, which means >>500km/tank. I would test this car for vacuum leaks, check codes and AFM signal with NissDataScan as D says, check plugs, do a compression check while they are out.
    • Duncan
      Pops when backing off throttle, rough-ish sound through rev range.

      By Duncan · Posted

      It is hard to be specific half way across the world...but it *seems* like it might have a minor issue. Is the idle stable and does it rev smoothly? I would not expect any pops out of what I am assuming is a standard ECU, standard tune, standard exhaust. You can use Nissan Data Scan to find out exactly what is happening when it runs, the cable/software is reasonably affordable if you are not planning on changing the ECU (which hopefully you are not with an NA skyline) BTW your mileage may not be that far off, these are heavy old tech cars, and being NA might mean you use a heavy foot to keep up with traffic....
    • AdiR34
      Pops when backing off throttle, rough-ish sound through rev range.

      By AdiR34 · Posted

      Hey guys! Y'all are the masters so figured I'd check in on a few items here. - My engine sounds ever-so-slightly more raspy than the other NA RB25s I've listened to. It's barely noticeable but definitely a slightly different sound. - When I back off the throttle at high RPM, I will sometimes get a pop out of the exhaust, assuming this can be diagnosed as misfire. Some history on the car: - Had an exhaust leak in auction sheet but was claimed to be fixed by seller (bought from USA importer).  - Car's coil packs and sparks were replaced when it was sold to me, but unsure on what the gap is and whether the coil packs are correct.  - A prior mechanic had misdiagnosed a pilot or throwout bearing sound as LSPI/detonation. Had played with timing a bit, pops/raspy sound of engine just got worse. Got timing reset. - Had failed emissions a few times. First time went in as is, failed. Second time, replaced cat, still failed, running rich as hell. Third time replaced o2 sensor, passed. Car still smells gassy though. - Timing belt and valve cover gasket also replaced.  - Gas mileage is... low. about 350-400K per tank.  Any idea if I'm having any serious issues here or does this all sound like normal old NA RB stuff and I'm fine to drive it with the pops/slightly raspy engine? If it'll help, I can get drop a video of the sound of the engine.
×
×
  • Create New...