Jump to content
SAU Community

Recommended Posts

Hey guys.

Ive landed 20 FuelStar units here. And all need to be sold. these things are awesome.

Now i take it most of you havent heard of these before. but they are just hitting the market now.

The fuelstar is a unit about 3 times the size of a typical fuel filter, that goes inbetween the fuel filter and the fuel rail. It adds an amount of tin to the petrol, which in turn:

-Gives more Power

-Greatly reduced fuel consumption

-Reduces emissions

-Allows leaded cars to run on unleaded

-Greatly reduces pinging and detonation

-Makes the petrol burn colder lowering engine temperatures

-Increases octane rating. (running 95ron fuel will be like running 98ron and running 98ron will be even higher)

And each fuelstar unit will last 500,000 k's

Dont know whether any of you saw at WA AutoSalon (a year or two back) there was a gtr on the dyno. made 220awkw then signs of pinging were detected. A fuel star was fitted without any other modification. the GTR then made 280awkw as the fuelstar allowed them to up the boost. and at this power level there was no signs of pinging or detonation at all.

For another example. I just fitted one in a mates 200sx S14. The safcII was showing knock readings of around 110 - 140 before. and tonight. it was reading around 40 - 60. with no other mods on the same boost....

There is a whole heap of info at Http://www.fuelstar.com including before and after dyno sheets of many cars. and info on everything it does.

Now these units are the PS245's and are available at $500 Including Postage to anywhere in australia.

Its really hard to stress how good these units are. nothing comes close to matching these interms of power/money...

I already have all units so you dont have to wait till a certain date. just reply here if you want one... and its all yours.

got 20 available. can get more if they sell....

Thanks guys.

damn thats a big outlay on your part. you must be really confident of this product. is it anything like that brocky majic magnet thingy ma jig? not trying to knock ya but $500 a pop, im sceptical. have you fitted this to your car yet and noticed anything?? any dyno sheets?

theres some more discussion bout these here if anyone is intersted in more info:

http://www.nissansilvia.com/forums/index.p...pic=90122&st=30

seems intersting but would be nice to see before and after dyno grpahs with everything else constant...

Fitted one of these about 3 years ago!! my car was pinging all over the place after i fitted it it ran smooth as a babies bum!! I am about to test a new and improved one ill let you know how it goes, Two thumbs up for fuel catylists.

damn thats a big outlay on your part.  you must be really confident of this product.  is it anything like that brocky majic magnet thingy ma jig?  not trying to knock ya but $500 a pop, im sceptical.  have you fitted this to your car yet and noticed anything??  any dyno sheets?

Mate. i guess im overly confident about this product.

it really is hard to stress just how good these are.

its not some fake thing that people sell like "hey, add this to your oil and gain 50rwkw!"

it really is the BEST value upgrade you can get.

if anyone can name a better one just say...

i have one in my car. but i dont have dyno sheets as i have just put in an rb25... and am yet to get it running due to ecu issues...

there are heaps of dyno sheets on the fuelstar site.... its well worth a look. and ill try get that video of auto salon with the gtr...

just read what trashed said... speaks for itself with results...

Listen. if anyone has a car in melbourne that pinging or something at the moment... buy one of these... fit it. and if it doesnt aid the car... i iwll give a full refund no questions.... as long as it is actually pinging... obviously its not going to fix piston slap or bearing noises.... :D

500 at first glance seems alot.. but its well worth it... like i said i cant stress how good these are.

  • 1 month later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...