Jump to content
SAU Community

Recommended Posts

The stock turbo is only efficient and effective upto 12psi MAX. You can put it up more but what you don't know is actually hurting your car, by this I mean, internally you wiping years off your engine.

I have been recommend by all mechanics that 12 is a absolute safe limit you want to sit on. Any more you need to start adding more fuel to compensate for the air. This means changing injectors, fuel pump, high flow fuel filter, fuel lines, Apexi PowerFC.

In order to unleash more power you may as well change the turbo.

Stock turbo is safe up to 14psi. After this you're putting too much strain on the ceramic exhaust wheel.

There's no point in upping the boost to 14psi if you keep the stock computer or don't run some sort of piggy back like an SAFC. The stock computer dumps a lot of fuel and retards the engine timing to protect the engine if you run higher boost. The result is a dyno curve that goes up and down and up and down. On the road this feels like surging.

I run 11psi w/ the stock turbo, Power FC, front mount, full 3" exhaust, high pressure fuel pump, and fuel pressure reg. When the new injectors are installed I'll run 14psi, and get the power FC retuned.

I use to run 11psi without the Power FC, fuel pump, and fpr. The power band was all over the place.

The turbo is located on the passenger side of the engine bay underneath a heat shield.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...