Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

Hi abto

my mates friend waited all afternoon for you to deliver the wing,you never turned up.what is going on?you had my number also.

please ring me 0408134419.

thanks stuart

Hi abto

How come you didn't deliver the wing to boxhill like we organised.when are you going to deliver please.we didn't even beat you down on the price.

thanks stuart

Hi abto

The wing is great sorry about the missunderstanding on tuesday,hope your car got fixed.My mate very happy and i will leave positive feed back

thanks stuart

sorry i havnt been on for long had some issues to deal with and i had a C*nt bump into my s15.

I need a quick sale on the GTR side skirts and 400R rear pods. I need them gone by saturday. Would like to sell them together but will seperate if i get a good price.

PLEASE pm me a price. pickup whenever

This is what the side skirts and rear pods look like on the car. THIS IS NOT MY CAR, but i found this r33 on my computer. If its your r33 just send me a pm and i will take the picture down.

Will swap for some s15 cwest side skirts plus cash adjustment

This is what the side skirts and rear pods look like on the car. THIS IS NOT MY CAR, but i found this r33 on my computer. If its your r33 just send me a pm and i will take the picture down.

Will swap for some s15 cwest side skirts plus cash adjustment

180 Pickup on the side skirts tonight.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...