Jump to content
SAU Community

Recommended Posts

Hey car is a 96 r33 s2, car has been fine until last night. I was driving along and was in third gear, i started to accelerate, the car got to about 3500rpm then cut-out for a second. It was like a big jerk. Then further up the road i tried again and the same thing happen.

Today i took it for a drive and it was fine, but tonight when i went to accelerate it happend again. Im starting to think it might have something to do with the colder weather at night?

I also thought it might be boost cut. It is currently set at 12psi. The only thing i have changed lately was the boost controller. I went from a no name bleed valve, to a turbotech ($22 one from the forums). I think it may be getting just under 13psi sometimes (when its colder).

Anyways just wondering if anyone could help out.

P.S sorry if this post is hard to read, but im not in a good writing mood right now

Thanks, Mike

:)

Link to comment
https://www.sau.com.au/forums/topic/78546-r33-problems-fuel-cut/
Share on other sites

Don't change your afm unless you change your ECU - it will stuff things up. The AFM isn't maxed out but the reading the ECU is getting is saying this is too much airflow (most likely), hence richening and retarding the timing which feels like a fuel cut.

Turn the boost down to 10psi. If it stil happens look to coil packs for issues.

check to make sure the boost controller does not have a blockage. This would cause the turbo to spike extremely quickly as the wastegate is not opening or not opening enough. Your boost cut should be somewhere around 20psi but the turbo will hit that twice as fast as your guage will read it so it might only say 13 or 14 psi but the turbo has already hit 20psi. It is unlikely to be your AFM as my stock rb20 afm is putting through 250 rwkw and only reaches maximum voltage when my injectors hit 100% duty cycle.

  • 7 months later...

sorry to dig up an old thread....

but im currently getting these exact symptims from my car

only running fm cooler, pod and 3" cat back and cars at 9.5psi

doesnt haven all the time.. but its like a big jerk when it does happen

would that be a boost cut... at 9.5psi? :rolleyes:

-Ruffels

  • 1 year later...
sorry to dig up an old thread....

but im currently getting these exact symptims from my car

only running fm cooler, pod and 3" cat back and cars at 9.5psi

doesnt haven all the time.. but its like a big jerk when it does happen

would that be a boost cut... at 9.5psi? huh.gif

-Ruffels

Im also getting the exact same problem. It seems to be worse at night and is definatly worse on higher boost, the higher the boost, the worse it is generally.

Has anyone found out what is actually causing this yet?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...