Jump to content
SAU Community

defected and speeding fine... great steps towards having a great day!!!


Recommended Posts

  • Replies 57
  • Created
  • Last Reply

Top Posters In This Topic

i actually believe that they do indeed check ur plates on their computer before they pull you over. Cant be a co-incidence that it happened twice in one night.

Youre absolutely right they do check ur number plates, if you've been defected they will pull you over even after you have had the defect cleared. MY advice to you after you have the defect cleared either get a peronalized number plate or sell your car. sorry for the harsh reality.

If a turbo timer was essential for turbo life Nissan would have incorporated it in as a factory item.

They dont include the turbo timer because its against the ADRs. Turbo Timers are only allowed on vehicles with a GCM of greater than 4.5 tonne.

There's no comparison between a car and a truck.

A truck is constantly up its turbo, simply turning off the motor WILL coke the oil lines. In a car that most of the time isn't boosting hard, its not an issue.

No doubt if there was a reliability issue in passenger vehicles the ADR's would have it incorporated.

The tt's fitted to the trucks also have to meet ADR's.

So really.. Its not just a turbo timer, its a turbo timer designed to meet ADR's. :P

The intended use of cars doesn't warrant a turbo timer.

I got defected yesterday in my R32, driving along doing NOTHING, bike cop pulled me over and defected me for too loud, and too low. The cop was nothing but an arogant w*nker on a power trip......

I dont see why they should defect a car when it is driving normally, fair enough id expect a defect if i was doing something stupid, but this is just bull s**t.!

thats unlucky.... i was speeding stupidly so i asked for it. 306rwkw.... you will have a fair few parts to un bolt off that power house!

I just hope that they dont single out imports and treat commonhoes and ford farm cars the same!

Thirtythree-II,

I got pulled over several years ago after just leaving my wifes work place and got checked for excessive noise running the same system as you except i had a dump pipe and race cat,and my reading came in 3db under what the sgt had on his form that was supposed to be the spec's for a ser II.( I might add that a stationary test like i had to perform doesnt comply with the adr's that stipulate that the vehicle must drive past a test device at a steady 60km's per hr in 4th gear and the the test device must be placed at 45 degrees to the path of the vehicle and be 'x' no of meters away from it!

Regards,

SKYLINE (Kym)...

Thirtythree,

I dont think it will make much difference to the over all volume of sound, however probably will give a deeper throaty growl on full song!

Regards,

SKYLINE (Kym)...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I don't know for sure, but I'd expect them all to be interchangeable given the diff end and hub end don't move/change between any C34 series. Often Nissan will change part numbers and the aftermarket follows those year ranges; but the original part number change doesn't mean other parts won't fit. The change could be a change in material, internal parts or even just supplier. For example, all the RB gearbox to engine bolts are no longer available and there is a new part number instead. The only change is they went from cadmium plated bolts to zinc plated due to the issues manufacturing with Cadmium. They look different but work the same.
    • One year is a bit concerning. Did you try contacting GSP? It says 5 year warranty on the box if I remember correctly. I'm also running their driveshafts on my S2 Stagea.   You could check the part numbers on Amayama for your year. Here's the link for my 1998 which gives the 39100-23U60 part number. Well, that and 39100-23U70. https://www.amayama.com/en/genuine-catalogs/epc/nissan-japan/stagea/wgnc34/6649-rb25det/trans/391 What does it say for yours?
    • I ordered a GSP Front R/H Axle from here - https://justjap.com/products/gsp-premium-front-driveshaft-r-h-nissan-r32-r33-r34-skyline-gtr-stagea-4wd#description It lasted around a year before one of the boots blew out. I'm lowered, but I have GKTech roll center adjusters. One year seems a little premature. I think I'm going to spend the extra money on an OEM cv axle this time. This website - https://tfaspeed.com/collections/nissan-stagea-wgnc34-x-four-parts/products/nissan-stagea-awc34-260rs-rb26-right-front-axle-drive-assembly Makes it sound like the readily available OEM CV axle will only fit 11.1999 Stagea and up (mine is a 2.1997 S1). The JustJap listing didn't mention any years or anything for the GSP axle. Amayama shows '11.1999' and up as well for that part number. As well as 'plastic boot type'. See attached picture. So I guess my question is, does that axle (39100-23U60) really only fit S2 Stagea? It's the front driver side. If it does, I'd love to buy that instead of rolling the dice on another GSP. I've found that OEM one cheaper here: https://www.partsfornissans.com/oem-parts/nismo-jdm-r32-r33-r34-skyline-gtr-r32-gts4-right-front-axle-3910023u60 and here https://www.nissanparts.cc/oem-parts/nismo-shaft-ft-drive-3910023u60 Just a little confused because the JapSpeed listing for the GSP front driver axle doesn't mention any specific years or anything and it fit my S1 Stagea fine. So will 39100-23U60 fit my S1 Stagea even though technically it says '11.1999' and up? What would have changed? Thanks.  
    • Thanks for the info. The only "Issue" I've had with the shifter is I always found the throw between 4th and 6th gear too close. I'm always worried to shift into 4th accidently and sending my motor to the moon. Adam LZ recently came out with a video and stated Serialnine revised their shifters to correct this and will change all the revised parts for 150$. Strangely enough, I contacted Serialnine right after and they denied it and said it's bullshit. I found that strange as he's a distributer. I'll keep this forum post updated on that saga.
    • Yep that is correct. It allows you to adjust the short throw range from what I can tell
×
×
  • Create New...