Jump to content
SAU Community

Recommended Posts

i should be getting a coil from a GTS-t from one of the WA members a bit cheaper. provided the turbo coils are the same for the NA engines.

where can you get replacement springs or 'carbon rods' from? don't they attach inside the coil somehow?

u can get some replacement springs from a Nissan dealership. they just pull in and out off the carbon rod on the inside of the coil pack.

You can get springs from L & T venebles, there's one in Wangara. They're like $2 for a pack of 4.

I used them in my R32. You don't NEED the little carbon bit, it runs fine with just the spring.

and you just pop them in the end? they don't need to be stuck in there? :whatsthat

That will be for the carbon canister, usually located passenger side, just in front of the (standard) air box.

mm it comes out of there and over the engine but doesn't attach to anything else. even though it has a clip on the end as if it had been attached to something.

SECUR1TY: can't see any carbon rod in there either :D its all just white dust etc

i'll have to double check them tonight i think.

dont worry about the carbon rods.. my bad

just stretch your springs slightly and get a little dremil drill with a sander attachment and sand away the layer of shit on the inside of the coil where the spring sits in to a nice shine.

you'll be amazed on how much crap comes out of it.. all that crap causes misfires on everyones car because it doesnt allow for a good contact between the coil and the spring... and then they go out and spend $700 on splitfires.. this is definately a good fix for it. mine have been running excellent since i did it.

haven't had time to get hold of springs or a dremel yet but managed to get a coil pack which i put in last night.

was slightly different to my others and the plug didn't quite fit properly, managed to rejig it and connect it but it still sounds like a wrex :)

so i've pulled it out again.

no idea why it didn't work, perhaps due to it not fitting correctly.

i think now i'll just get someone out to look at it, don't want to do more harm than good.

well.. a coil for another engine wouldnt work, i imagine.

completely different application.

give the sanding a go before you take it anywhere. go to any nissan dealer for the springs or even a wrecking yard

well.. a coil for another engine wouldnt work, i imagine.

completely different application.

give the sanding a go before you take it anywhere. go to any nissan dealer for  the springs or even a wrecking yard

the coil pack was from an R33 GTS-t which i was informed is the same as mine.

the guy looking at it tomorrow is currently putting an RB25 into a 200sx so he should know his way around ok.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...