Jump to content
SAU Community

Recommended Posts

hi guys just seeking some help on my car at the moment its a r34 gtt, today when i tried to start it, the engine was running on 5 cyl's only and the engine, slip, and tcs off light all came on and stayed on any help appreciated, is there a self test to retreive trouble codes how do i do it?

cheers

Link to comment
https://www.sau.com.au/forums/topic/86053-r34-trouble-codes/
Share on other sites

Pull out the consult connect that is under the dash on the driver side of the steering column.

Look on the back of the connector and find 2 wires on their own in one corner.

Turn the car to (I think) accessory.

Get a paper clip and short out these 2 wires.

Watch the check engine light for flashes.

I think the first number of the code is long flashes and the second number is quick flashes.

5-5 means end of codes.

2-1 = flaaaaaaaash flaaaaaaash flash

if you get a 21, then it is something with your ignition. Most likely coilpack has died.

Ha, apparently all 34GTt does that, my mate's car does that every freaking time as well. Got PFC, tuned by Melb top tuner and still. Mind you nothing wrong with the performance, everytime it does that thing we just rev the shit out of it and it fix itself LOL.

Maybe should consider Slitfire system.

It will blow a bit of black smoke cos ' stock ECU trigger alarming so shit load of fuel goes through.

We now had PFC installed and the fcuking thing still happening, if it was really a coil pack then it'll goes to that safemode ( TCS and shits lights up ) for good, why it only come on once in a while?

i wouldn't be driving it mate the car felt pretty fcked and rough when it was happening. As for revving the car till it owrks i wouldn't be doing that either.

Id garage the car till you get it fixed.

but serioulsy when my car was doing the exact same thing it was just a coil i changed it and it worked fine!!!

  West said:
It will blow a bit of black smoke cos ' stock ECU trigger alarming so shit load of fuel goes through.

We now had PFC installed and the fcuking thing still happening, if it was really a coil pack then it'll goes to that safemode ( TCS and shits lights up ) for good, why it only come on once in  a while?

You're talking out of your ass mate.

The car is over fueling because the coilpack isn't working.

Thus the sparkplug is not firing so the unburnt fuel goes out the exhaust.

It still happens with the PFC because the coilpack is dead.

If you don't know what you're talking about or are uncertain, please don't spread it around like it's factual.

Why does it only come up once in a while?

Because they get faulty when it's hot, run them like that long enough and the coilpack will not work even on cold starts.

  ed said:
You're talking out of your ass mate.

The car is over fueling because the coilpack isn't working.

Thus the sparkplug is not firing so the unburnt fuel goes out the exhaust.

It still happens with the PFC because the coilpack is dead.

If you don't know what you're talking about or are uncertain, please don't spread it around like it's factual.

Why does it only come up once in a while?

Because they get faulty when it's hot, run them like that long enough and the coilpack will not work even on cold starts.

Wow wow wow, relax man, if i'm wrong then Hit me with your knowlege don't listen to my ass and get agro.

  mad34 said:
west i am with ed

what you have said sounds really stupid thats all.  

Its like saying my kid is sick so i will beat it until it gets better.

mad34

my kid is sick, ive beatn her so much shes bleeding from her eyes and she's still sick?

Should i keep going?

Edited by Driver

i had a similar problem with mine except car was running fine, the check engine light came on intermittently and when i revved the car a little it would go away. Brought it in to my mech who had a consult machine and found out it was a faulty O2 sensor. replaced tht and fixed the problem. I believe tht would be West's problem as the O2 sensor on the 34 have been known to play up. But if your car is running like shit and misfiring etc........then I would suspect the coilpacks. Nevertheless bring it in to a mechanic...most mechanics have the scan tool nowadays...good luck!

  n15m0 said:
i had a similar problem with mine except car was running fine, the check engine light came on intermittently and when i revved the car a little it would go away.  Brought it in to my mech who had a consult machine and found out it was a faulty O2 sensor.  replaced tht and fixed the problem.  I believe tht would be West's problem as the O2 sensor on the 34 have been known to play up.  But if your car is running like shit and misfiring etc........then I would suspect the coilpacks.  Nevertheless bring it in to a mechanic...most mechanics have the scan tool nowadays...good luck!

Well guess what, today and now that i remember most of other days as well on me mate R34, that stupid thing HAPPENED when the car is COLD so tell me, when the car is cold, the coil pack is HOT? :lol: :lol:

Well thanks all for the help, i got a replacement coil pack on thursday ( thanks ed ) and have been driving the car alot since then and no signs of any trouble at all, so fingers crossed the rest of the coil packs can hold out till i can get some splitfires cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • But first....while I was there, I also swapped across the centre console box for the other style where the AV inputs don't intrude into the (very limited !) space.  Part# was 96926-4GA0A, 284H3-4GA0B, 284H3-4GA0A. (I've already swapped the top 12v socket for a USB bulkhead in this pic, it fit the hole without modification:) Basically to do the console you need to remove the DS and PS side console trim (they slide up and back, held in by clips only) Then remove the back half of the console top trim with the cupholders, pops up, all clips again but be careful at the front as it is pretty flimsy. Then slide the shifter boot down, remove the spring clip, loose it forever somewhere in the car the pull the shift knob off. Remove the tiny plastic piece on DS near "P" and use something thin and long (most screwdrivers won't fit) to push down the interlock and put the shifter down in D for space. There is one screw at the front, then the shifter surround and ashtray lift up. There are 3 or 4 plugs underneath and it is off. Next is the rear cover of the centre console; you need to open the console lid, pop off the trim covering the lid hinge and undo the 2rd screw from the driver's side (the rest all need to come out later so you can do them all now and remove the lid) Then the rear cover unclips (6 clips), start at the top with a trim tool pulling backwards. Once it is off there are 2 screws facing rearwards to remove (need a short phillips for these) and you are done with the rear of the console. There are 4 plugs at the A/V box to unclip Then there are 2 screws at the front of the console, and 2 clips (pull up and back) and the console will come out.
    • So, a bit of a side trip, but one that might be interesting for people with JDM cars and japanese head units. I know @Pac previously posted about a carplay/android auto adapter he installed which used the AUX input, and @V35_Paul put in one of the Tesla style units that replace both screens. The option I went with was a Lsait LLT-YF-VER5.87_2 (https://www.alibaba.com/product-detail/Lsailt-8GB-Android-Multimedia-Interface-for_1601187633672.html). Price was $1,150 for a single unit although they are much cheaper if you are willing to buy 2....$857ea. Make you you get the version 2 not version 1, it is faster and has a better UI - this is the manufacturer listing: http://www.lsailt.com/product/348.html. BTW if you've never bought from Alibaba before, don't be concerned....these guys can't stay in business unless they are responsive, ship fast etc, they were excellent (probably faster shipping than most local places) So, this was my task for a lazy Sat afternoon....looks complex but was all done in a few hours (it probably helps that I had some of it apart before so it was a bit familiar). I also decided to add a HD USB drive recorded at the same time and the unit also supports an aftermarket reverse cam (if you don't want to retain factory) and also AV in and HDMI out It looks much worse than it is, in fact in was genuinely all plug and play (no custom wiring at all). This video was pretty good (skipped a few steps), unfortunately they are an Aussie seller but no longer sell this unit (I guess Carplay/AA adapters are easier to install and much cheaper) https://www.youtube.com/watch?v=T5hJfYOB8Dg
    • That still isn't a lot to go on. I don't have a Y50 Fuga Head Unit wiring diagram. I can say that a lot of nissans of that age shared head unit plugs, so if you are in Australia something like this would probably help: https://aerpro.com/app091# You plug that into the car loom, then either plug the head unit ISO into that (if it has ISO), or you buy and ISO adapter harness that you wire in. Bit of stuffing around, but once you have ISO its easy to change things in future.
    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
×
×
  • Create New...