Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

well i went to kalamunda high for my first two years where most of it spent at wet n wild across the road getting a degree in chatting up guys there. The rest of my time was spent in form kicking the guys arses at comand and conquer - my form teacher let me get away with anything - they had these stupid talks by people like overeaters annoymonous i used to wag and i would get let off - the guys do it and got detention hehe.

My parents caught onto me running amok and therefore put me in a private school in the middle of nowhere - it didnt help haha.

wasnt that i was dumb in fact i got into all the smart classes etc just had a bad attention span and a fun loving nature haha still do ;)

Why are we to blame paul? i dont work for the government im just a lowly contractor hence why im being shoved out.

haha nah i didnt sleep with anyone i was a good little innocent back then ;) Did work out that battering my eyelids got me my own way tho - haha i had quite a few people wrapped around my little finger.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Have you confirmed its the actual axles? Also the wheel bearings that mount on the hubs to hold the axles wear out. I replaced mine as they got play in them. It sorted my play issue. 
    • Ive converted a few clusters for the R33 with 320km/h dials. On the back there are some pads which can be bridged or unbridged (using solder or wick braid) to calibrate it. There is one bridge which is for MPH <> KPH; and there are combinations of bridges to offset it. There is probably a diagram  For example; this is my conversion for a 180km/h dial to a 320km/h dial (I put custom GT-R dials on it with the GTS25t layout) If you have J2 soldered (assuming the S clusters have a similar config to the R clusters); you may need to remove that solder
    • Back on topic 😉, these are some of the notable pages from the booklets that are supplied with each weekly parts update. I never knew the BNR32 test mule car had an S13 Silvia body...
    • This. A 3d wheel alignment is like $120...just take it to the shop. Since theres probably multiple adjustments that need to be made after changing something. Mine has front/rear lower arms, traction rods, tension rods, camber arms, toe arms, front upper arms, hicas kit, sway bars and coilovers. I measure from the edge of the bolt holes on the originals and set the same length on all the adjustable stuff to dial it as close as I could to OEM. Took it straight for alignment; it didnt feel right at all...after alignment, it feels perfect. Similarly i've just changed the springs on another car; and I still needed multiple adjustments to bring it back in spec.
    • A full Veilside kitted JZA80 Supra in Meriken park in Kobe city a few weeks back
×
×
  • Create New...