Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by bully

Paul is it true you where at Chivias Marine looking at Marlin boards for your new wing?

No but Ben Lexcan was looking at Australia 2 , then pwptf's wing , then the Americas cup and said

* Bondy , I got a new idea *

Cheers

Ken

Originally posted by GTS-t VSPEC

Ken,

I measure my work in nanoseconds, makes it look like I do something:bahaha:

Bully, No need to get nasty, ain't like Supra wings are subtle:p

See'ya:burnout:

Strange , Niz said your work was measured in Nanoseconds as well. Hehehe

Cheers

older but laster

Ken

Originally posted by GTS-t VSPEC

Ken,

Alot of thought went into this wing:p

What do you think of vented bonnets for track racing, good idea?

See'ya:burnout:

Ohh... shit ... a serious topic.

Ahheemm.

Paul , vented bonnets are great for the track which is why you can't use em .lol.

No opening allowed unless factory and no rearward facing scoop ( ala A9X ) at all.

Engine blow ups on the w/screen are not good.

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...