Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

hey guys - flying visit to say hello - im going to bed reaall early tonight - got an early start in the morning and i have to be nice to people and not grumpy so im going to have to have plenty of sleep to make that all happen :D

Originally posted by Nizmo

hey guys - flying visit to say hello - im going to bed reaall early tonight - got an early start in the morning and i have to be nice to people and not grumpy so im going to have to have plenty of sleep to make that all happen :D

Hi Niz , bye Niz hope all goes well for tomorrow and stay off the champagne at breakfast.

Cheers

Ken

have to be there at 6:45 get up at 5.30 too! yuk!

no champagne unfortunately - i think the little japanese i did learn in school may come in handy haha my dad actually got an invite to this but he was going to send one of his managers who didnt end up registering *sob* so i no longer have any company just me and a room full of older business men - might find myself a sugar daddy haha

Originally posted by skyzerr33

u can do that to my balls on friday sexy

As Joe said you 2.

GET A ROOM.

Sheesh , your worse than Niz and pwpt60secf.:D

Sorry to hear about the loan Kyles.

Ahh well , Joondalup just isn't quite ready yet for maniac moped ( oops , scooter ) riders .

Try getting a s/hand one ?

cheers

Ken

Originally posted by Nizmo

have to be there at 6:45 get up at 5.30 too! yuk!  

no champagne unfortunately - i think the little japanese i did learn in school may come in handy haha my dad actually got an invite to this but he was going to send one of his managers who didnt end up registering *sob* so i no longer have any company just me and a room full of older business men - might find myself a sugar daddy haha

If that is a room of older Jap men , I can 100% gaurantee that a 6' blonde female single roundeye will get more than 1 sugar daddy.:D

They would go nuts in Japan over you.

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...