Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

I've changed my home loan from a std 25 year mortgage to a offset/equity loan. I bought the house 2.8years ago for $85,000 its now been valued by the bank at $110,000. I've got the loan down to $70,000 by paying a bit extra each fortnight for the lasy 2.8years, so I've taken a low offset/equity loan at $82,000. So I've got a bit of extra cash lying around incase I need it, but cos its an offset loan I should pay it off much quicker than the std 25 year loan. Its a bit confusing but I sat down and did the figures, going as I was the 25 year loan would be paid off in another 12 years with the new offset loan it'll be closer to 3-5 years depending on how frugal I am, quicker if my wife gets another job too :( Stupid education dept wont give her a job in the metro area :P So yeah, we want some french doors to open out onto our courtyard and I want to do more work on the car :)

Powerfc will set me back around $1700 delivered new with controller, then plus fitting and tuning. The autronics is $3500 drive in and out, but has boost control built in (if I want to sell the blitz sbc will make the install cheaper), traction control, serial port connection to a laptop with easy to use PC software so I can **** with maps when I know what I'm doing.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...