Jump to content
SAU Community

Recommended Posts

Well mothers day was very slack, Troy and i didnt get up till 1 thisarvo, went to mums, came home and then i took troy boy out to dinner for his bday but i fell down the stairs at my house on the way and im really sore :) We had a booking for 2 but i ended inviting my mum and sister and they couldnt fit 2 more on the table, even though they managed to seat a groups of 4 or more while we where waiting for our take out that we ended up getting from the aisn restaurant. We yelled at them for that. Not going back there.

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

no he didnt. My sister did but. Mum was really worried about my back and troy was behind me (he didnt push me) so i didnt see if he was smiling though and holding back the laugh. It was a pretty bad fall and troy boy picked me up. My ankle is slightly swollen. I should be ok. Going to have some wopping bruses though.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...