Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Well after have some thieves try on several occasions to steal my VL turbo a few years ago I can say that the ol 33 is very tightly tucked away.... They would have to be very very keen to try to take it.... But still you don't want to hear about these things soo close too home...

they pushed it 200m down the road

i have an alarm with door, boot bonnet, and glass brakeage sensors, also have an immoboliser, but they got past it some how.

They ripped out the ignition barrel to break the stearing lock so they could push it down the road.

It was insured with the RAC 3rd party fire and theft. They told me i have an escess of $1050 so i told em to get ****ed

the thing i had stolen where

panasonic 4x45 head unit

pioneer 220w 6x9

pioneer 4 channel amp

rockford fosgate 12" sub in sealed box

splitfire 5" monster tachoi w/shift light

plus not to mention how my car was left...

back seat was onm the road, carpet ripped up everywhere.

all panels wires etc ripped out and left hanging everywhere.

what i can get over is they stole the whole rear parcel shelf, they wheren't satisfied with just the speakers im guessing :)

Hi Guys,just came back from SST. We couldnt push the car to redline because the boost was creeping TOO much. So im gonna go back with a profec EBC and theyre gonna port my wastegate hole too. But without even pushing it to redline my car made 274HP,this was at erm 140+km/h i think

-so theres lots more potential left in them steve reckons

Guest
This topic is now closed to further replies.



  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...