Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Well after have some thieves try on several occasions to steal my VL turbo a few years ago I can say that the ol 33 is very tightly tucked away.... They would have to be very very keen to try to take it.... But still you don't want to hear about these things soo close too home...

they pushed it 200m down the road

i have an alarm with door, boot bonnet, and glass brakeage sensors, also have an immoboliser, but they got past it some how.

They ripped out the ignition barrel to break the stearing lock so they could push it down the road.

It was insured with the RAC 3rd party fire and theft. They told me i have an escess of $1050 so i told em to get ****ed

the thing i had stolen where

panasonic 4x45 head unit

pioneer 220w 6x9

pioneer 4 channel amp

rockford fosgate 12" sub in sealed box

splitfire 5" monster tachoi w/shift light

plus not to mention how my car was left...

back seat was onm the road, carpet ripped up everywhere.

all panels wires etc ripped out and left hanging everywhere.

what i can get over is they stole the whole rear parcel shelf, they wheren't satisfied with just the speakers im guessing :)

Hi Guys,just came back from SST. We couldnt push the car to redline because the boost was creeping TOO much. So im gonna go back with a profec EBC and theyre gonna port my wastegate hole too. But without even pushing it to redline my car made 274HP,this was at erm 140+km/h i think

-so theres lots more potential left in them steve reckons

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...