Jump to content
SAU Community

Recommended Posts

use a small screwdriver to remove the 2 hose clamps, and remove. No real trick to it, you may find it easier to remove the filter from the braket to get to bottom hoseclamp

rememebr to wait for engine to cool down so you dont burn yourself on intake manifold

i just went to parts store and asked for one to fit my car.

though i might add, the stock one has a bend in one of the pipe's going into filter. the replacement they gave me, the line was straight. It worked fine, but i couldnt get the filter back in the braket

ps. check your other thread

If you go to autobarn or where ever you should be able to look the part number for a fuel filter up in the book.

The one without the bend in the pipe is for 300zx i think.

lol my names rhett 2... never met another 1..

Hey, your the 4th Rhett ive met. It took me until i was 18 to meet another person called Rhett.

What's the best way to do it without spilling fuel everywhere? As obviously when the filter is taken off the bottom clamp, and fuel in the lines is going to go everywhere? :)

I've got a spare fuel filter and have been meaning to swap it over for a while but have never gotten around to it.

What's the best way to do it without spilling fuel everywhere?  As obviously when the filter is taken off the bottom clamp, and fuel in the lines is going to go everywhere?  :P

I've got a spare fuel filter and have been meaning to swap it over for a while but have never gotten around to it.

Yank the fuel pump fuse and let the car die. Try and turn it over a couple of times and you will use up most of the remaing petrol. Have a rag to catch the rest.

  • 2 weeks later...

I used Z 201 cost 11$ .It has straight top/out piping so You have to replaced fuel hose for longer one ,half meter 7.5 mm cost about 9 $.

Or You can use a Z 387 cost about 38$ same bended top pipe as genuine one.

Its not a problem to change I did two R 32 today .Take me few minutes .Pul out filter with smal hose from botom pipe ,than change filter out of tha car and put back filter with smal hose and top big hose already back on to botom pipe.

Fuel here is real shit so You need to replaced fuel filter at least every 10000 kms.

If You can not for same reason change fuel filter and have something to do in Brisbane ,come to my place I can changed for You.No problem.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
    • Ah coolant overflow, previous discussions make way more sense now lol. 
×
×
  • Create New...