Jump to content
SAU Community

Recommended Posts

I am slightly concerned...

My car has recently begun blowing the slightest bit of smoke at idle... It looks black... which I spose is better than white..

Also the car doesn't idle very well when warm.. when its cold it has a nice smooth idle, but after it warms up it is constantly hunting.

At around the same time I cut the speed limiter wire (No. 53)

I know that wouldn't have anything to do with it, but I am also thinking maybe the harness isnt plugged back in as tight as it could be??

I will check the harness later, but I thought I'd ask you guys what you think..

Link to comment
https://www.sau.com.au/forums/topic/91500-smoke-and-idle/
Share on other sites

There are 2 coolant temp sensors.

One for the dash and one for the ecu.

The one for the ecu controls coolant temp injector enrichment.

Have it reading cool all the time and it will be fine when the motor is cold but bad when the motor is warm. As you said, a little bit of black smoke on idle.

Most likely the afm, but still worth the look if its not.

Edited by Cubes
Link to comment
https://www.sau.com.au/forums/topic/91500-smoke-and-idle/#findComment-1649998
Share on other sites

interesting.. I swapped the rhs one on mine a couple of months ago and no diff so I just figured that probably wasn't the problem.. maybe i should investigate too :P

I think I may have narrowed mine to old fuel pump though.. now inplace is a GTR one, problem seems to have gone in 20 mins of testing tonight.

Link to comment
https://www.sau.com.au/forums/topic/91500-smoke-and-idle/#findComment-1650027
Share on other sites

its definitely the LHS connector.. you are right... pays to check the service manual :P.. Diagnostics are on page EN-384 of the RB20DET service manual if you have.

If you have a multimeter you can measure whether they are in spec..

I have tried most things but mine has always been a bit over the shop.. seemed better with the pump though (lack of fuel at low revs?). I'm off to clean the *proper* temp sensor right now... see whether that clears it up totally.

Link to comment
https://www.sau.com.au/forums/topic/91500-smoke-and-idle/#findComment-1650062
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...