Jump to content
SAU Community

Recommended Posts

Call Howard at Racebrakes Melbourne. I buy from there regularly and just give CC details and shipping address and next day I have product.

Don't know he'd waste time on cockroaches though. :)

hehe, d'oh sprung!

i realised you were talking to mr arrowz, so with drew the stab at our souther neighbours.

i guess with you being from queensland we are all:

(cue frankie:)

"south of the border, down mexico waaaaaay"

Yeah, I'll probably just give Race Brakes in Melbourne a call.

Mind you, Nissan's got a promotion with DBA at the moment, so they're selling their rotors relatively cheaply at the moment. They can get everything from your standard replacement to full 5000's.

Otherwise, the guys at Sports Car International are good with Nissan cars without being a Nissan dealer.

Of course, you can always give Mu's Secret a call and see if you can't get Project Mu brake hardware. From what I've heard their stuff is pretty good.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...